Manual browser: lseek(2)

Section:
Page:
LSEEK(2) System Calls Manual LSEEK(2)

NAME

lseek, seekreposition read/write file offset

LIBRARY

Standard C Library (libc, -lc)

SYNOPSIS

#include <unistd.h>

off_t
lseek(int fildes, off_t offset, int whence);

DESCRIPTION

The lseek() function repositions the offset of the file descriptor fildes to the argument offset according to the directive whence. The argument fildes must be an open file descriptor. lseek() repositions the file pointer fildes as follows:
  • If whence is SEEK_SET, the offset is set to offset bytes.
  • If whence is SEEK_CUR, the offset is set to its current location plus offset bytes.
  • If whence is SEEK_END, the offset is set to the size of the file plus offset bytes.

The lseek() function allows the file offset to be set beyond the end of the existing end-of-file of the file. If data is later written at this point, subsequent reads of the data in the gap return bytes of zeros (until data is actually written into the gap).

Some devices are incapable of seeking. The value of the pointer associated with such a device is undefined.

RETURN VALUES

Upon successful completion, lseek() returns the resulting offset location as measured in bytes from the beginning of the file. Otherwise, a value of -1 is returned and errno is set to indicate the error.

ERRORS

lseek() will fail and the file pointer will remain unchanged if:
[EBADF]
fildes is not an open file descriptor.
[EINVAL]
whence is not a proper value, or the resulting file offset would be invalid.
[ESPIPE]
fildes is associated with a pipe, socket, or FIFO.

SEE ALSO

dup(2), open(2)

STANDARDS

The lseek() function conforms to IEEE Std 1003.1-1990 (“POSIX.1”).

HISTORY

A seek() function appeared in Version 2 AT&T UNIX, later renamed into lseek() for “long seek” due to a larger offset argument type.

BUGS

This document's use of whence is incorrect English, but is maintained for historical reasons.
April 3, 2010 NetBSD 7.0