|
BLACKLISTCTL(8) |
System Manager's Manual |
BLACKLISTCTL(8) |
NAME
blacklistctl — display and change the state of blacklistd
SYNOPSIS
|
blacklistctl |
dump [-abdnrw] |
DESCRIPTION
blacklistctl is a program used to display the state of
blacklistd(8)
The following options are available:
-
-a
-
Show all database entries, by default it shows only the embryonic ones.
-
-b
-
Show only the blocked entries.
-
-d
-
Increase debugging level.
-
-n
-
Don't display a header.
-
-r
-
Show the remaining blocked time instead of the last activity time.
-
-w
-
Normally the width of addresses is good for IPv4, the -w flag, makes the display wide enough for IPv6 addresses.
NOTES
Sometimes the reported number of failed attempts can exceed the number of attempts that
blacklistd(8) is configured to block. This can happen either because the rule has been removed manually, or because there were more attempts in flight while the rule block was being added. This condition is normal; in that case
blacklistd(8) will first attempt to remove the existing rule, and then it will re-add it to make sure that there is only one rule active.
HISTORY
blacklistctl appeared in NetBSD 7.
AUTHORS
Christos Zoulas
